anonzwhgkqab
- 合計アクティビティ 16
- 前回のアクティビティ
- メンバー登録日
- フォロー 0ユーザー
- フォロワー 0ユーザー
- 投票 0
- サブスクリプション 1
アクティビティの概要
anonzwhgkqabさんの最近のアクティビティ-
anonzwhgkqabさんがコメントを作成しました:
Deryck: Well, that's what I thought initially, and that's how I first programmed the parameter for register address 11, with the enumeration showing each of the values, but it still only came back ...
-
anonzwhgkqabさんがコメントを作成しました:
Deryck: Sorry, this is the table I was trying to show you: I set the mask for the values 0, 3, and 5 according to the following example: The masks for values 1,2, and 4 were programmed this way, ...
-
anonzwhgkqabさんがコメントを作成しました:
deryck: I'm going to try to contact Cummins Tech Support to see if they can shed any light on the State parameter. In the meantime, I have another issue I'm trying to figure out. When I go to the...
-
anonzwhgkqabさんがコメントを作成しました:
Deryck: I will leave the issue for the "state' register for the moment, on to the other question. Registers 44 and 45 contain the engine runtime in seconds. Please see the following screen shot s...
-
anonzwhgkqabさんがコメントを作成しました:
Deryck: I really don't have any more information to refer to, other than the list of registers and the parameter they report, any multiplier or offset applicable, and the units of the value. For t...
-
anonzwhgkqabさんがコメントを作成しました:
Deryck: I did go in and remove the 40000 offset from all the parameters and now I can read several of them, looks like I may have to play with the multiplier a little bit in some cases. The genera...
-
anonzwhgkqabさんがコメントを作成しました:
Deryck: Something odd is going on, I had to reset my password on hms this morning to login, and now my new password isn't working. Robert Akins
-
anonzwhgkqabさんがコメントを作成しました:
Deryck: Here are examples of the template parameter settings I am using: And the same register in the ModLon II manual (Gen0):
-
anonzwhgkqabさんがコメントを作成しました:
Deryck: Exactly what does a Modbus Illegal Data Address error mean to Netbiter? All my template register addresses are set to the values listed in the ModLon II installation guide for the default ...
-
anonzwhgkqabさんがコメントを作成しました:
Hi Deryck: The account name is DENTON_CO2; when I go to Browse Devices to the generator controller, click the drop down to show the parameters and hit the refresh button; after about 20-30 seconds ...