Kyle Reynolds
- Actividad total 669
- Última actividad
- Miembro desde
- Siguiendo 0 usuarios
- Lo siguen 3 usuarios
- Votos 17
- Suscripciones 180
Comentarios
Actividad reciente de Kyle Reynolds-
Yes, DeviceNet is UPPER, EIP is LOWER.
-
Hi @Michael, You don't need the EDS if you use a generic module. I wouldn't be concerned about the "node not yet initialised" status as there are many reasons why the web page might have shown that...
-
This is the EDS file you need to use: 005A000C004B0300.EDS (15.4 KB) If you can't use the EDS use a Generic IO device.
-
That serial number can't be right. What is the serial number that is printed on the device?
-
Hi @Michael, It's probably a mismatch because of the odd number of bytes. Can you try to make that 36/28? The addressing is based on registers and can't address a half register. This should work w...
-
Hi @Michael, Glad to hear you got that working! If AutoScan is Enabled, the Scanner will automatically scan the network for slave devices and add them to the network. The X-gateway allows the Ether...
-
@Michael, In order to Upload or Download scanlist, you need to be online with the scanner (there needs to be an active bus), which is why you need viable DeviceNET cables and terminators. We can do...
-
Hi @Dewy, They actually don't need to open a port on the firewall because the Flexy is using outbound traffic to connect to the VPN, which is typically allowed by default. The IT department probabl...
-
Hi @Michael, The Anybus-M DEV Rev 3. 7 is the correct one, which you can confirm by importing the EDS file. The picture looks right. I assume you installed EDS files for 1-4 already, have bus power...
-
You should power down the device before inserting or removing the SD Card.