anonzwhgkqab
- Total activity 16
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 1
Activity overview
Latest activity by anonzwhgkqab-
anonzwhgkqab commented,
Deryck: Well, that's what I thought initially, and that's how I first programmed the parameter for register address 11, with the enumeration showing each of the values, but it still only came back ...
-
anonzwhgkqab commented,
Deryck: Sorry, this is the table I was trying to show you: I set the mask for the values 0, 3, and 5 according to the following example: The masks for values 1,2, and 4 were programmed this way, ...
-
anonzwhgkqab commented,
deryck: I'm going to try to contact Cummins Tech Support to see if they can shed any light on the State parameter. In the meantime, I have another issue I'm trying to figure out. When I go to the...
-
anonzwhgkqab commented,
Deryck: I will leave the issue for the "state' register for the moment, on to the other question. Registers 44 and 45 contain the engine runtime in seconds. Please see the following screen shot s...
-
anonzwhgkqab commented,
Deryck: I really don't have any more information to refer to, other than the list of registers and the parameter they report, any multiplier or offset applicable, and the units of the value. For t...
-
anonzwhgkqab commented,
Deryck: I did go in and remove the 40000 offset from all the parameters and now I can read several of them, looks like I may have to play with the multiplier a little bit in some cases. The genera...
-
anonzwhgkqab commented,
Deryck: Something odd is going on, I had to reset my password on hms this morning to login, and now my new password isn't working. Robert Akins
-
anonzwhgkqab commented,
Deryck: Here are examples of the template parameter settings I am using: And the same register in the ModLon II manual (Gen0):
-
anonzwhgkqab commented,
Deryck: Exactly what does a Modbus Illegal Data Address error mean to Netbiter? All my template register addresses are set to the values listed in the ModLon II installation guide for the default ...
-
anonzwhgkqab commented,
Hi Deryck: The account name is DENTON_CO2; when I go to Browse Devices to the generator controller, click the drop down to show the parameters and hit the refresh button; after about 20-30 seconds ...