Tim Beaulieu

  • Total activity 191
  • Last activity
  • Member since
  • Following 0 users
  • Followed by 0 users
  • Votes 0
  • Subscriptions 46

Comments

Recent activity by Tim Beaulieu Recent activity Votes
    1. Community
    2. Ewon - Flexy
    3. Get tags from plc (s7-1500)

    Hi Jairo, You should be able to read tags from an S7-1500, but what do you mean by symbolic directionality?

    1. Community
    2. Ewon - Flexy
    3. eWON File Transfer

    Hi Leo, You should be able to do something like what is seen below: ondate monthly email.txt (994 Bytes) RG-006-0-EN-(Programming Reference Guide).pdf (865.6 KB) This is setup to run on the first o...

    1. Community
    2. Ewon - Flexy
    3. eWON File Transfer

    Hello, This is something that will need to be done through BASIC unfortunately. I think this should be possible by just making a counter with a delay that will send out an email for each of the 12 ...

    1. Community
    2. Ewon - Flexy
    3. eWON - Offline issues

    I generally wouldn't recommend updating devices remotely just in case the device goes offline. But you don't need to worry about losing configuration settings just from a firmware update

    1. Community
    2. Ewon - Flexy
    3. BASIC IDE Delay Logic

    You should just be able to put all of the TSETs in the top of your section. I'd avoid putting them in a goto function unless you want to change the value of a TSET.

    1. Community
    2. Ewon - Flexy
    3. BASIC IDE Delay Logic

    Can we set up a time for you to call me to go over more of this if you're still running into issues with the code above? Thanks, -Tim

    1. Community
    2. Ewon - Flexy
    3. BASIC IDE Delay Logic

    So in the code that I provided, it is based off of an ontimer. This means that it will execute the code each time that ontimer is reached. In this case it will be triggering on a counter that will ...

    1. Community
    2. Ewon - Flexy
    3. BASIC IDE Delay Logic

    You could either have 4 different initializes that cause the code to run, or you could have it so the initialize triggers on 4 different values

    1. Community
    2. Ewon - Flexy
    3. BASIC IDE Delay Logic

    I think that this might help you if you need multiple delays for a tag. It's only using one Tset and is just using an additional tag as a counter to create the delays. multidelay example.txt (552 B...

    1. Community
    2. Ewon - Flexy
    3. BASIC IDE Delay Logic

    Hi PJ, the Initialize that I created was to just turn the counter on. The way I wrote it was basically so that it's calling a tag on the Flexy called Initialize and when it sees that value change i...