Zach Farmer
- Total activity 42
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 1
- Subscriptions 14
Activity overview
Latest activity by Zach Farmer-
Zach Farmer commented,
The WiFi extension card cannot be used as an access point. It only connects to other access points for its own internet connection.
-
Zach Farmer commented,
The WiFi Extension card is for the Flexy's WAN connection to get internet so it would be connecting to either a hot spot or an existing network. If you are trying to access the flexy or land device...
-
Zach Farmer commented,
Hi, The status tag is an internal tag to see if the flexy has communication with the device. In tag creation you choose the IO Server that is being used, the topic that was setup, and in the addres...
-
Zach Farmer commented,
Hi, We had an update of the ewon website. The files are now located on the drawing section of this page for the flexy 205. https://www.ewon.biz/technical-support/resources/downloads-and-documentati...
-
Zach Farmer commented,
Hi, If you go to the account tab in eCatcher you can choose report and it will have the monthly consumption reports that list the number of SMS that have been sent. The Flexy can show when an alarm...
-
Zach Farmer commented,
Hi mark, Can you look at the ewon's configuration page when you are connected and check the hardware side to see if the device is set to 192.168.1.160? Also check the properties tab in eCatcher for...
-
Zach Farmer commented,
Hi Mark, If you run the command ipcomfig in the command prompt is it showing any of your connections as being in the same range? Also when you are pinging the devices what message is showing up?
-
Zach Farmer commented,
Hi Mark, Try closing out of eCatcher and changing your computer IP to be out of the cosy's subnet. After doing this you should be able to each those devices.
-
Zach Farmer commented,
We don't have tutorials, but there are examples located on this page. https://developer.ewon.biz/content/basic-1 We also have a reference guide that discusses the synax and gives example code. ...
-
Zach Farmer commented,
You can have the Flexy read an incoming sms by writing a script in the BASIC IDE. Here is an example we have. https://developer.ewon.biz/content/sms-reception-ewon