This troubleshooting guide applies when a VPN connection to the Ewon Edge has been successfully established, but one or more LAN devices behind the Ewon Edge cannot be reached remotely through Ewon Cloud. Several conditions can prevent communication with LAN devices, including a conflicting network adapter on the remote computer, Ewon Edge Remote Access security settings, or incompatible network/subnet configuration.
APPLICABLE PRODUCTS
Ewon Edge
Ewon Cloud
ISSUE
After successfully establishing a remote connection, LAN devices connected to the Ewon Edge cannot be reached. You may see ping timeout, unreachable response, browser timeout, or software connection failure.
ANSWER
-
Network Adapter Conflict
When an Ewon Cloud remote access session is established, the Ewon Cloud Connector uses a network interface that routes traffic destined for the remote LAN through the VPN tunnel. Other network adapters or VPN software installed on the computer may conflict with the Ewon Cloud Connector adapter.
Fig 1. Ewon Cloud Network Adapter
Troubleshooting Steps:
Temporarily disable network adapters that are not required for your current Internet connection or Ewon Cloud connection, then test access to the LAN device again. Common examples include other VPN clients, virtual machine adapters, and PLC simulation software such as Siemens PLCSIM.
-
Restricted Mode set and LAN device undeclared
Ewon Edge remote access can operate at different security levels filtered by Ewon Cloud, including Open Mode and Restricted Mode. When Restricted Mode is enabled, remote users can only access devices and services that have been defined under Remote Session > Links. If the LAN device, IP address, or required service/port has not been defined correctly, the connection will be blocked.
In Open Mode, remote access is not limited to the individually defined links. You are free to access any LAN devices on the configured subnet(s).
Troubleshooting Steps:
Define your LAN devices while in Open Mode then to be sure you can reach them. Then try Restricted Mode to see if the filtering blocks anything. If you are in Restricted Mode, go to Remote Session > Links then click the Add link button.
Fig 2. Remote Session Links Example
To change which security mode your Ewon is using, go to Remote Session > Links then click the gear icon.
Fig 3. Remote access security settings
-
LAN device is in an incompatible subnet
For an Ewon Edge LAN interface to communicate directly with a LAN device, the Edge interface and LAN device normally need to be configured within the same IP subnet. If they are located on different subnets, additional routing must be configured between those networks.
For example, if the Ewon Edge LAN interface is configured as 192.168.2.1/24, a directly connected LAN device could use an address such as 192.168.2.10/24.
Also verify that the LAN device's subnet mask is configured correctly. An incorrect subnet mask can prevent the device from determining whether the Ewon Edge is on its local network.
Troubleshooting Steps:
You have a few options to fix your LAN device being on an incompatible subnet.- Change your Ewon LAN Port's IP address to be a compatible subnet to your LAN Device's subnet.
- Change your LAN Device's IP address to be within the Ewon LAN Port's subnet.
- Use a router or level 3 managed switch to route between the Ewon Edge's LAN port and the LAN device.
- Add another subnet to the Ewon's LAN.
ADDITIONAL INFO
What is restricted mode for Ewon Edge and how do I use it effectively