This article will show you how to enable the extended KNX Group Addressing to support group addresses above 15/7/255, if it is not enabled, Intesis MAPS will generate a pop-up message that says Invalid Sending Error.
APPLICABLE PRODUCTS
- KNX AC Interfaces Multi Unit configured via Intesis MAPS (INKNXFGL016O000, INKNXHIS016O000, INKNXHIS064O000, INKNXHIT016O000, INKNXHIT064O000, INKNXLGE016O000, INKNXLGE064O000, INKNXMIT015C000, INKNXMIT100C000, IN776MHI00SO000, IN776MHI00MO000, IN776MHI00LO000, INKNXPAN016O000, INKNXPAN064O000, INKNXSAM004O000, INKNXSAM008O000, INKNXSAM016O000, INKNXSAM064O000).
- KNX Protocol Translator Gateways configured via Intesis MAPS (IN701KNX1000000, IN701KNX2500000, IN701KNX6000000, IN701KNX1K20000, IN701KNX3K00000, INKNXDAL0640200, INKNXMEB0100000, INKNXMEB0200000, INKNXMEB0600000, INKNXMEB1200000)
PRE-REQUISITES
- Connected Gateway.
- Newest MAPS version installed.
IN THIS ARTICLE
In the standard configuration you can assign the group addresses from 0/0/1 to 15/7/255 in our gateway, if you want to use more ( up to 31/7/255 ) activate the "Extended Addresses" function in the KNX section under the configuration tab.
ADDITIONAL INFO
To know more about how to use the Intesis MAPS configuration tool, check out our Intesis MAPS eLearning courses
© HMS Networks AB 2023