Howard burghdurf
- 活动总数 11
- 最后的活动
- 成员加入日期
- 正在关注 0 名用户
- 关注者数 0 名用户
- 投票数 0
- 订阅数 1
活动概览
Howard burghdurf 的最新活动-
Howard burghdurf 进行了评论，
So there is this "CIP" section in the HMS users manual: Can this be used to get the Diag Data via a Msg Instruction?Not clear on how this would be set up....Below is My stab at it:
-
Howard burghdurf 进行了评论，
Any Thoughts?
-
Howard burghdurf 进行了评论，
I did try to "enable Alarms" in the parameters, and also checked the DPV1 box.... But that check box doesn't Un-Gray any of the other items on that Tab: And doesn't result in any additional "mappi...
-
Howard burghdurf 进行了评论，
sent under the Ticket
-
Howard burghdurf 进行了评论，
sent via a ticket
-
Howard burghdurf 进行了评论，
How do you attach files?
-
Howard burghdurf 进行了评论，
I do not... I'll be onsite Probably next Wed. and provided I can access the equipment I could get that info.In the Mean time getting back to What I want...In the Mass Flow Controller (I sent the...
-
Howard burghdurf 进行了评论，
I am remote so I can't access the equipment... It is pretty old (2018?)
-
Howard burghdurf 进行了评论，
So is the Firmware the Hardware Firmware version.... and is the "Configuration Manager" part of the "Firmware"?
-
Howard burghdurf 创建了一个帖子，
EN2PB-R Profibus Node Diagnostics
My understanding about the Profibus Protocol is there is Diagnostic Information that should be part of each Nodes transmission? It doesn't appear the the Gateway (or Configuration Manager SW?) map...