Kyle Reynolds
- 活动总数 665
- 最后的活动
- 成员加入日期
- 正在关注 0 名用户
- 关注者数 3 名用户
- 投票数 17
- 订阅数 180
评论
Kyle Reynolds 最近的活动-
You are very welcome.
-
You can reply to either the email directly or on the forum and I'll see it, so whichever you prefer.
-
@ADubberly, So if you are setting up a static address on the WAN, you are not going to be able to run the internet connection test (unless your network is using the same IP subnet as them) so you w...
-
So you want NAT on LAN (Plug'n Route) selected in the NAT and TF section, and you do not want NAT 1:1 enabled. I didn't mean to catch that section in the screen shot. It needs to look like this: i...
-
You're welcome. I will close the ticket for now, but you can re-open by just responding to this message. Thank you, Kyle
-
After reviewing the previous ticket and logs it looks like you could not get online when the device was set to DHCP because it was not receiving an IP address from the network, but when a static IP...
-
Have you already made the change to NAT on LAN (Plug'n Route)? The logs are indicating that you are not getting an IP address from DHCP on the network again. I think the only way we're going to be ...
-
Do you have an SD card in this device? anything plugged into the USB port? It's getting stuck in a reboot loop and rebooting before much has been documented in the logs, immediately after the WAN p...
-
Hi Randy, I don't think the settings changing are related to the connection issue between the HMI and PLC. If we check the event logs, we can see if there are any errors involving the switch. It's ...
-
Good Morning Randy, Taking a look at the logs there are a few different errors that may be related to the communication problem: 1555672606 19/04/2019 11:16:46 eip-receive socket error during read...