hms_support
- 活动总数 87
- 最后的活动
- 成员加入日期
- 正在关注 0 名用户
- 关注者数 0 名用户
- 投票数 0
- 订阅数 30
评论
hms_support 最近的活动-
If you want to return the device back to factory settings, you will need to perform a second level reset. Level 2 Reset Instructions NOTE: These instructions are for the COSY 141 device ONLY and wi...
-
Typically in a scenario such as this something on the PC is restricting the network traffic (between the eWON and your PC). The most common causes are: · Firewall traffic restrictions · ...
-
@Bill_Davies Yes, that is correct.
-
@Bill_Davies The ewon uses an N-channel MOSFET with the drain is syncing power and would be the negative side of your circuit. If this is done in reverse you could see the light work the opposite ...
-
@anonzsaorytb To allow internet to LAN devices on the Flexy, you will need to change parameters in the interface to allow for WAN TO LAN traffic. Instructions: Firmware < 12.2 Does not apply to Fle...
-
@Tucker_Dan_Baldwin-A To reset the device back to factory defaults then you will need to do a level 2 reset. Page 25 of the Cosy 131 manual reviews this process: ig-0022-00-en-cosy-131.pdf In...
-
@tedsch RS232 is also supported, and we support full and half duplex. I'd take a look the FLA3301 extension card manual for additional details regarding the extension card as well as it may help wi...
-
@Mikewo Thank you for the clarification. Typically people will use the remote access of the eWON and VPN into the LAN. I thought this was the case. We do have a static routing table in the eWON for...
-
@tedsch You should be able to use Modbus RTU over RS485 or RS422 to communicate with the Flexy using the FLA3301 serial extension card. We also have a document related to this PLC's Directsoft soft...
-
@RichFranzo The eWON will only be able to read a maximum of 32 bits.Double floats are not natively supported in the eWON due to this (64 bits).