anonzwhgkqab
- 活动总数 16
- 最后的活动
- 成员加入日期
- 正在关注 0 名用户
- 关注者数 0 名用户
- 投票数 0
- 订阅数 1
活动概览
anonzwhgkqab 的最新活动-
anonzwhgkqab 进行了评论，
Deryck: Well, that's what I thought initially, and that's how I first programmed the parameter for register address 11, with the enumeration showing each of the values, but it still only came back ...
-
anonzwhgkqab 进行了评论，
Deryck: Sorry, this is the table I was trying to show you: I set the mask for the values 0, 3, and 5 according to the following example: The masks for values 1,2, and 4 were programmed this way, ...
-
anonzwhgkqab 进行了评论，
deryck: I'm going to try to contact Cummins Tech Support to see if they can shed any light on the State parameter. In the meantime, I have another issue I'm trying to figure out. When I go to the...
-
anonzwhgkqab 进行了评论，
Deryck: I will leave the issue for the "state' register for the moment, on to the other question. Registers 44 and 45 contain the engine runtime in seconds. Please see the following screen shot s...
-
anonzwhgkqab 进行了评论，
Deryck: I really don't have any more information to refer to, other than the list of registers and the parameter they report, any multiplier or offset applicable, and the units of the value. For t...
-
anonzwhgkqab 进行了评论，
Deryck: I did go in and remove the 40000 offset from all the parameters and now I can read several of them, looks like I may have to play with the multiplier a little bit in some cases. The genera...
-
anonzwhgkqab 进行了评论，
Deryck: Something odd is going on, I had to reset my password on hms this morning to login, and now my new password isn't working. Robert Akins
-
anonzwhgkqab 进行了评论，
Deryck: Here are examples of the template parameter settings I am using: And the same register in the ModLon II manual (Gen0):
-
anonzwhgkqab 进行了评论，
Deryck: Exactly what does a Modbus Illegal Data Address error mean to Netbiter? All my template register addresses are set to the values listed in the ModLon II installation guide for the default ...
-
anonzwhgkqab 进行了评论，
Hi Deryck: The account name is DENTON_CO2; when I go to Browse Devices to the generator controller, click the drop down to show the parameters and hit the refresh button; after about 20-30 seconds ...