support
- 活动总数 32
- 最后的活动
- 成员加入日期
- 正在关注 0 名用户
- 关注者数 0 名用户
- 投票数 0
- 订阅数 8
活动概览
support 的最新活动-
support 进行了评论，
Hello, Yes, sorry for the inconvenience. CANopen is an protocol that sits on top of a CAN bus. So CANopen defines the object module and what certain messages and CAN IDs mean in the communication ...
-
support 进行了评论，
Hello, If the Fanuc Robot controller is also a PROFINET IO slave device then you will need a PLC like you mentioned. The configuration of this gateway is straightforward because it is a slave on b...
-
support 进行了评论，
Hello, Yes, this will have been addressed in the new versions being released. Nick
-
support 进行了评论，
Nope, you should be all set, you also have a good day! Nick
-
support 进行了评论，
If you are not using Modbus the Modbus addressing mode does not matter. Although it is listed there you can just ignore it. Best regards, Nick
-
support 进行了评论，
Hello, Modbus is supported in the event the application calls for it. You certainly do not need to use it, so you can just ignore that functionality. Thanks! Nick
-
support 进行了评论，
Hello, This did turn out to be a known issue, Trevor found the following. "The IP address for my Linking Device was 192.168.150.171. I tried changing it to something completely different (10.10.0....
-
support 进行了评论，
I have informed a support colleague in Sweden of this behavior. I am going to update him and ask him his thoughts.
-
support 进行了评论，
Have you ever been able to launch the configuration interface? Or has it given this message from the very beginning? You are plugged into the X1 ports on the front, correct?
-
support 进行了评论，
We have not encountered this exact issue, however I would suggest uninstalling and reinstalling the AOP. This is how you can reinstall it, Navigate to this directory "C:\Program Files (x86)\Rock...