Anybus Profinet IO

Jarin Lee

• 2024年08月13日 11:14

I'm currently trying to use the control/status module in TIA program however, it seems to be that module isn't responding as it should. I looked at a previous post of someone describing the same issue with the fix being to just add 2byte IO module instead I tried this with no luck. I must be doing something wrong. Help if possible.

0

• 

  Kyle Reynolds

  • 2024年08月13日 13:24

  It may be that the bytes need to be reversed. PROFINET is big endian and Ethernet/IP is small endian, for example. 

  0
• 

  Jarin Lee

  • 2024年08月13日 18:14

  Ok, that would just change the structure of the data coming in, right?.......because there is no data. We are trying to monitor the status of the canbus for comms.

  0
• 

  Siobhan Chapman

  • 2024年08月19日 08:32

  Can you tell us the part number of the Anybus gateway you are using? This will help us to give the correct advice.

  For more specific support, and the ability to share your configuration with the support team here at HMS, please open a support ticket.

  0

请先登录再写评论。