Howard burghdurf
- Atividade total 11
- Última atividade
- Membro desde
- Seguindo 0 usuário
- Seguido por 0 usuário
- Votos 0
- Assinaturas 1
Visão geral da atividade
Atividade mais recente por Howard burghdurf-
Howard burghdurf comentou,
So there is this "CIP" section in the HMS users manual: Can this be used to get the Diag Data via a Msg Instruction?Not clear on how this would be set up....Below is My stab at it:
-
Howard burghdurf comentou,
Any Thoughts?
-
Howard burghdurf comentou,
I did try to "enable Alarms" in the parameters, and also checked the DPV1 box.... But that check box doesn't Un-Gray any of the other items on that Tab: And doesn't result in any additional "mappi...
-
Howard burghdurf comentou,
sent under the Ticket
-
Howard burghdurf comentou,
sent via a ticket
-
Howard burghdurf comentou,
How do you attach files?
-
Howard burghdurf comentou,
I do not... I'll be onsite Probably next Wed. and provided I can access the equipment I could get that info.In the Mean time getting back to What I want...In the Mass Flow Controller (I sent the...
-
Howard burghdurf comentou,
I am remote so I can't access the equipment... It is pretty old (2018?)
-
Howard burghdurf comentou,
So is the Firmware the Hardware Firmware version.... and is the "Configuration Manager" part of the "Firmware"?
-
Howard burghdurf criou uma publicação,
EN2PB-R Profibus Node Diagnostics
My understanding about the Profibus Protocol is there is Diagnostic Information that should be part of each Nodes transmission? It doesn't appear the the Gateway (or Configuration Manager SW?) map...