jivanqui
- Atividade total 15
- Última atividade
- Membro desde
- Seguindo 0 usuário
- Seguido por 0 usuário
- Votos 0
- Assinaturas 1
Visão geral da atividade
Atividade mais recente por jivanqui-
jivanqui comentou,
Morning Deryck This configuration works well now. No more problem in hardware plc siemens. The LEDs on the communicators are as follows: 1 - GREEN, 2 - OFF, 3 - OFF, 4 - OFF, 5 - RED, 6 - GREEN fl...
-
jivanqui comentou,
Hi Deryck I did the same procedure to another communicator, for humity equipement, restored to the default mailbox configuration, and works well too. Now I can install both anybus communicator in m...
-
jivanqui comentou,
Hi Deryck Sorry, yesterday we have a maintenence in stop line, because this I can´t work in the problem anybus. The node id I adjust for 11 (eleven), but I change many times. I already change for o...
-
jivanqui comentou,
Deryck How I can do the factory resset?
-
jivanqui comentou,
Hi Deryck The LEDs on the communicators are as follows: 1 - OFF, 2 - RED, 3 - OFF, 4 - OFF, 5 - RED, 6 - GREEN flashing
-
jivanqui comentou,
Morning Deryck, I did a new test: I put a remote intead gateway, make a new configuration for a new hardware, and you can see the result in pictures bellow: image825Ã709 119 KB image708Ã618 936 ...
-
jivanqui comentou,
Sorry, I didn´t undertand. I already download the hardware of plc. But is possible for me do this again anytime is necessary.
-
jivanqui comentou,
hi Deryck "Is there communication on the bus?" - I don´t think so, because only side profibus e pc are connect, the RS232 are disconnected. I´m working in laboratory far from the equipment. "Is the...
-
jivanqui comentou,
Ok Deryck I did the configuration for Data location, works well. image1023Ã638 88.1 KB I configurated the new words in plc program, but the problem coninuous image1137Ã647 173 KB Another sugges...
-
jivanqui comentou,
Ok Deryck Thanks for your help. I tried to change in plc hardware your suggestion, but not work. I check in subnetwork monitor like you show, and I can see that I´ve a colision at In Area, like in ...