AB9006 with Fanuc robot Ethernet/IP config
The robot still does not communicate with the heater. I have sent snap shots of the settings and the IO that was given to me by TCP.
If you have any ideas that would be apricated.
-
Can you show me the config in the Anybus?
0 -
I have sent you a backup. And a snippet of the IP config screen.
X-gw009c.cfg (2.7 KB)
0 -
It just says offline line. This usually means that a setting is not right. I can ping the unit just fine so I know I have direct connection.
0 -
Also, do you get any errors?
0 -
Just that the scanner is off line when I try to go on line.
0 -
Can we do a screen share with Teamviewer to go over this today?
It looks like you have all the correct settings, but I'm not at the lab so I can't check the whole config file. I am also not 100% sure about the Connection Type setting (Run/Idle Header, Zero-length, modeless, heartbeat). Are you using the settings they gave you for those? Everything else looks perfect.
0 -
Yes I will be free to do this after lunch at 12:35
0 -
Just let me know when you want to connect.
0 -
Can we do around 1:45 EST?
0 -
Just need an invitation
0 -
Can we do it now?
0 -
Here is my TeamViewer information to connect to my computer.
Thanks,
0 -
You can contact my IT Manager, he is working on getting you connected. His number is
0 -
sounds good
0 -
Can't find your phone number
0 -
Thanks again. The attached are pictures of the settings that got changed.
0
Por favor, entrar para comentar.
Comentários
16 comentários