Howard burghdurf
- 合計アクティビティ 11
- 前回のアクティビティ
- メンバー登録日
- フォロー 0ユーザー
- フォロワー 0ユーザー
- 投票 0
- サブスクリプション 1
アクティビティの概要
Howard burghdurfさんの最近のアクティビティ-
Howard burghdurfさんがコメントを作成しました:
So there is this "CIP" section in the HMS users manual: Can this be used to get the Diag Data via a Msg Instruction?Not clear on how this would be set up....Below is My stab at it:
-
Howard burghdurfさんがコメントを作成しました:
Any Thoughts?
-
Howard burghdurfさんがコメントを作成しました:
I did try to "enable Alarms" in the parameters, and also checked the DPV1 box.... But that check box doesn't Un-Gray any of the other items on that Tab: And doesn't result in any additional "mappi...
-
Howard burghdurfさんがコメントを作成しました:
sent under the Ticket
-
Howard burghdurfさんがコメントを作成しました:
sent via a ticket
-
Howard burghdurfさんがコメントを作成しました:
How do you attach files?
-
Howard burghdurfさんがコメントを作成しました:
I do not... I'll be onsite Probably next Wed. and provided I can access the equipment I could get that info.In the Mean time getting back to What I want...In the Mass Flow Controller (I sent the...
-
Howard burghdurfさんがコメントを作成しました:
I am remote so I can't access the equipment... It is pretty old (2018?)
-
Howard burghdurfさんがコメントを作成しました:
So is the Firmware the Hardware Firmware version.... and is the "Configuration Manager" part of the "Firmware"?
-
Howard burghdurfさんが投稿を作成しました:
EN2PB-R Profibus Node Diagnostics
My understanding about the Profibus Protocol is there is Diagnostic Information that should be part of each Nodes transmission? It doesn't appear the the Gateway (or Configuration Manager SW?) map...