Howard burghdurf
- Activité totale 11
- Dernière activité
- Membre depuis
- Abonné à 0 utilisateur
- Abonnés 0 utilisateur
- Votes 0
- Abonnements 1
Aperçu des activités
Dernière activité effectuée par Howard burghdurf-
Howard burghdurf a ajouté un commentaire,
So there is this "CIP" section in the HMS users manual: Can this be used to get the Diag Data via a Msg Instruction?Not clear on how this would be set up....Below is My stab at it:
-
Howard burghdurf a ajouté un commentaire,
Any Thoughts?
-
Howard burghdurf a ajouté un commentaire,
I did try to "enable Alarms" in the parameters, and also checked the DPV1 box.... But that check box doesn't Un-Gray any of the other items on that Tab: And doesn't result in any additional "mappi...
-
Howard burghdurf a ajouté un commentaire,
sent under the Ticket
-
Howard burghdurf a ajouté un commentaire,
sent via a ticket
-
Howard burghdurf a ajouté un commentaire,
How do you attach files?
-
Howard burghdurf a ajouté un commentaire,
I do not... I'll be onsite Probably next Wed. and provided I can access the equipment I could get that info.In the Mean time getting back to What I want...In the Mass Flow Controller (I sent the...
-
Howard burghdurf a ajouté un commentaire,
I am remote so I can't access the equipment... It is pretty old (2018?)
-
Howard burghdurf a ajouté un commentaire,
So is the Firmware the Hardware Firmware version.... and is the "Configuration Manager" part of the "Firmware"?
-
Howard burghdurf a créé une publication,
EN2PB-R Profibus Node Diagnostics
My understanding about the Profibus Protocol is there is Diagnostic Information that should be part of each Nodes transmission? It doesn't appear the the Gateway (or Configuration Manager SW?) map...