support
- Activité totale 32
- Dernière activité
- Membre depuis
- Abonné à 0 utilisateur
- Abonnés 0 utilisateur
- Votes 0
- Abonnements 8
Commentaires
Activité récente par support-
Hello, Yes, sorry for the inconvenience. CANopen is an protocol that sits on top of a CAN bus. So CANopen defines the object module and what certain messages and CAN IDs mean in the communication ...
-
Hello, Unfortunately not, the CM CANopen module does not support CAN 2.0B. J1939 is actually a protocol that uses CAN bus. CANopen is a totally separate protocol that is unrelated to J1939. Best ...
-
Hello, If the Fanuc Robot controller is also a PROFINET IO slave device then you will need a PLC like you mentioned. The configuration of this gateway is straightforward because it is a slave on b...
-
Hello, Yes, this will have been addressed in the new versions being released. Nick
-
Nope, you should be all set, you also have a good day! Nick
-
If you are not using Modbus the Modbus addressing mode does not matter. Although it is listed there you can just ignore it. Best regards, Nick
-
Hello, Modbus is supported in the event the application calls for it. You certainly do not need to use it, so you can just ignore that functionality. Thanks! Nick
-
Hello, I received this feedback, Please set the DLC as in the below attached programming example: static void TransmitMessage() { CANMSG pCanMsg = new CANMSG(); // no transmission delay pCan...
-
Hello, I will have to ask a colleague about this, I will let you know what they say. Thanks! Nick
-
Hello, If you would like more information please feel free to ask here or your local HMS support office. Thanks! Nick