Howard burghdurf
- Actividad total 11
- Última actividad
- Miembro desde
- Siguiendo 0 usuarios
- Lo siguen 0 usuarios
- Votos 0
- Suscripciones 1
Resumen de la actividad
Última actividad de Howard burghdurf-
Howard burghdurf hizo un comentario,
So there is this "CIP" section in the HMS users manual: Can this be used to get the Diag Data via a Msg Instruction?Not clear on how this would be set up....Below is My stab at it:
-
Howard burghdurf hizo un comentario,
Any Thoughts?
-
Howard burghdurf hizo un comentario,
I did try to "enable Alarms" in the parameters, and also checked the DPV1 box.... But that check box doesn't Un-Gray any of the other items on that Tab: And doesn't result in any additional "mappi...
-
Howard burghdurf hizo un comentario,
sent under the Ticket
-
Howard burghdurf hizo un comentario,
sent via a ticket
-
Howard burghdurf hizo un comentario,
How do you attach files?
-
Howard burghdurf hizo un comentario,
I do not... I'll be onsite Probably next Wed. and provided I can access the equipment I could get that info.In the Mean time getting back to What I want...In the Mass Flow Controller (I sent the...
-
Howard burghdurf hizo un comentario,
I am remote so I can't access the equipment... It is pretty old (2018?)
-
Howard burghdurf hizo un comentario,
So is the Firmware the Hardware Firmware version.... and is the "Configuration Manager" part of the "Firmware"?
-
Howard burghdurf creó una publicación,
EN2PB-R Profibus Node Diagnostics
My understanding about the Profibus Protocol is there is Diagnostic Information that should be part of each Nodes transmission? It doesn't appear the the Gateway (or Configuration Manager SW?) map...