schwag02
- Actividad total 10
- Última actividad
- Miembro desde
- Siguiendo 0 usuarios
- Lo siguen 0 usuarios
- Votos 0
- Suscripciones 1
Resumen de la actividad
Última actividad de schwag02-
schwag02 hizo un comentario,
Yes. I am using DiaSys 2.7 which is MTU software. I need the IXXAT Interface option in the control panel to set default hardware. This is not contained in the OEM software but the Windows config...
-
schwag02 hizo un comentario,
This is in the control panel that I am referring to. The earlier picture in the tread will not show up on Windows 10.
-
schwag02 hizo un comentario,
Yes. It shows up and seems like values are streaming but there is no place to set as default hardware like the IXXAT Interfaces would allow.
-
schwag02 hizo un comentario,
Is there any place in the options of the CANalyzer is set it as the default driver? I think that is the only piece that I am missing without having the IXXAT interface module. The CANalyzer seems...
-
schwag02 hizo un comentario,
Windows%20101425Ã730 134 KB I have a tech you responded this below: Yes, mine has windows 10. I have been using it now with diasys for about a year and a half. I was using the V2 and V3 drivers. ...
-
schwag02 hizo un comentario,
Is this a normal error or is this for a different hardware? My issue has been for USB to CAN II. Maybe I posted under wrong thread. Please let me know. Thanks
-
schwag02 hizo un comentario,
Yes. I am exactly referring to the V2 drivers and need the IXXAT interface to set the hardware as default hardware for the program and connection to occur. Were you able to establish this?
-
schwag02 hizo un comentario,
Ok. I downloaded it and will see what will be needed from there.
-
schwag02 creó una publicación,
VCI V2 with windows 10 USB-2-can
I am just trying to get the IXXAT Interface in the control panel and the V2 driver would be the only way to make this work but does not seem to load with Windows 10.