hms_support
- Actividad total 87
- Última actividad
- Miembro desde
- Siguiendo 0 usuarios
- Lo siguen 0 usuarios
- Votos 0
- Suscripciones 30
Comentarios
Actividad reciente de hms_support-
@Bill_Davies Yes, that is correct.
-
@Bill_Davies The ewon uses an N-channel MOSFET with the drain is syncing power and would be the negative side of your circuit. If this is done in reverse you could see the light work the opposite ...
-
@anonzsaorytb To allow internet to LAN devices on the Flexy, you will need to change parameters in the interface to allow for WAN TO LAN traffic. Instructions: Firmware < 12.2 Does not apply to Fle...
-
@Tucker_Dan_Baldwin-A To reset the device back to factory defaults then you will need to do a level 2 reset. Page 25 of the Cosy 131 manual reviews this process: ig-0022-00-en-cosy-131.pdf In...
-
@tedsch RS232 is also supported, and we support full and half duplex. I'd take a look the FLA3301 extension card manual for additional details regarding the extension card as well as it may help wi...
-
@Mikewo Thank you for the clarification. Typically people will use the remote access of the eWON and VPN into the LAN. I thought this was the case. We do have a static routing table in the eWON for...
-
@tedsch You should be able to use Modbus RTU over RS485 or RS422 to communicate with the Flexy using the FLA3301 serial extension card. We also have a document related to this PLC's Directsoft soft...
-
@mikewo You'll have to setup a path in the remoting PC so that it knows how to route through that gateway and reach the desired network " Example (assume 24 bit subnet mask for this example): eWON ...
-
@RichFranzo You could try reading these 4 Word registers separately and compute the 32 bit equivalent value in BASIC and store it in a Tag. However, you will lose precision when doing this. RG-006-...
-
To add onto this thread, we can exchange not only tag data (as seen above) but also files using the m2web API. Please see the following topic for more information:Exchange Data File between 2 Flexies