Profihub B5+R
Hallo, I`ve got a Profihub B5+R. Its serial number is startinh with number 23. My question is, Can i set profihub to diagnostic any slaves? I tried to set rotary switch to number 3. If i connect combrics to network, comrics show me new profibus slave with bus address 126. It`s OK /this is in manual/, but why doesnt show me a new information windoe with profihub diagnostic slave info. Do I need some special licence for combrics, or other smecial combrics?
Thx for your answer
Viktor
-
Hello Viktor,
Thank you for your question.
The rotary switch set to position 3 is indeed the correct setting. In this mode, the ProfiHub B5+R acts as a PROFIBUS diagnostic slave. If COMbricks detects a new device at address 126, this indicates that the diagnostic function is active.
No special COMbricks license is required for viewing the ProfiHub diagnostics. In our setup, COMbricks provides a dedicated ProfiHub diagnostics page, where detailed information such as the ProfiHub firmware version, power supply status, redundancy status, and channel alarms can be viewed.
Could you please let us know:
-
Which COMbricks firmware version you are using?
-
Which firmware version is running on your ProfiHub B5+R?
-
Do you see the diagnostic slave at address 126, but no "ProfiHub diagnostics" entry in the COMbricks menu?
-
If possible, could you send a screenshot of what COMbricks shows?
This will help us determine why the diagnostic information is not being displayed.
Best regards,
Calvin Busscher
Technical Support Engineer
IDS EMEA
0 -
Iniciar sesión para dejar un comentario.
Comentarios
1 comentario