Howard burghdurf
- Total activity 11
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 1
Comments
Recent activity by Howard burghdurf-
So there is this "CIP" section in the HMS users manual: Can this be used to get the Diag Data via a Msg Instruction?Not clear on how this would be set up....Below is My stab at it:
-
Any Thoughts?
-
I did try to "enable Alarms" in the parameters, and also checked the DPV1 box.... But that check box doesn't Un-Gray any of the other items on that Tab: And doesn't result in any additional "mappi...
-
sent under the Ticket
-
sent via a ticket
-
How do you attach files?
-
I do not... I'll be onsite Probably next Wed. and provided I can access the equipment I could get that info.In the Mean time getting back to What I want...In the Mass Flow Controller (I sent the...
-
I am remote so I can't access the equipment... It is pretty old (2018?)
-
So is the Firmware the Hardware Firmware version.... and is the "Configuration Manager" part of the "Firmware"?