Howard burghdurf
- Total activity 11
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 1
Activity overview
Latest activity by Howard burghdurf-
Howard burghdurf commented,
So there is this "CIP" section in the HMS users manual: Can this be used to get the Diag Data via a Msg Instruction?Not clear on how this would be set up....Below is My stab at it:
-
Howard burghdurf commented,
Any Thoughts?
-
Howard burghdurf commented,
I did try to "enable Alarms" in the parameters, and also checked the DPV1 box.... But that check box doesn't Un-Gray any of the other items on that Tab: And doesn't result in any additional "mappi...
-
Howard burghdurf commented,
sent under the Ticket
-
Howard burghdurf commented,
sent via a ticket
-
Howard burghdurf commented,
How do you attach files?
-
Howard burghdurf commented,
I do not... I'll be onsite Probably next Wed. and provided I can access the equipment I could get that info.In the Mean time getting back to What I want...In the Mass Flow Controller (I sent the...
-
Howard burghdurf commented,
I am remote so I can't access the equipment... It is pretty old (2018?)
-
Howard burghdurf commented,
So is the Firmware the Hardware Firmware version.... and is the "Configuration Manager" part of the "Firmware"?
-
Howard burghdurf created a post,
EN2PB-R Profibus Node Diagnostics
My understanding about the Profibus Protocol is there is Diagnostic Information that should be part of each Nodes transmission? It doesn't appear the the Gateway (or Configuration Manager SW?) map...