Andreas Stobe
- Total activity 52
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 1
- Subscriptions 28
Articles
Recent activity by Andreas Stobe-
Which information is important when processing a support request for a CAN interface board?
This article helps diagnose and resolve issues with Ixxat CAN interface cards by guiding users through key system checks and support steps. APPLICABLE PRODUCTS CAN-IB100/PCIe, CAN-IB200/PCIe, CA...
-
Why does the CAN-IB300/400/PCIe appear in the device manager with a yellow exclamation mark?
This article explains how to improve the detection of the CAN-IB300/400/PCIe by disabling PCI Express Native Control. APPLICABLE PRODUCTS CAN-IB300/PCI, CAN-IB400/PCI QUESTION Why does the CAN...
-
Is there an activatable CAN termination resistor on my Ixxat CAN interface board?
This article explains the availability of CAN termination resistors on Ixxat CAN interface boards. APPLICABLE PRODUCTS CAN-IB100/PCIe, CAN-IB200/PCIe, CAN-IB300/PCI, CAN-IB400/PCI, CAN-IB520/...
-
Why is my CAN bus not working properly?
This article addresses communication issues on the CAN bus when using Ixxat CAN-IB PCIe boards and USB-to-CAN interfaces. It guides users through essential checks such as wiring, termination, b...
-
CAN Pin Assignment
Pin assignment reference for Ixxat CAN interfaces (Sub-D9, RJ45, Header CAN connector) APPLICABLE PRODUCTS CAN-IB100/PCIe, CAN-IB200/PCIe, CAN-IB300/PCI, CAN-IB400/PCI, CAN-IB520/PCIe mini, C...
-
Why did the CAN transceiver on my CAN interface board break?
This article outlines the voltage tolerance and protection guidelines for CAN transceivers and emphasizes which overvoltage that CAN transceivers can withstand. APPLICABLE PRODUCTS CAN-IB100/PC...
-
Is a CAN interface board with or without galvanic isolation more suitable for my CAN network?
This article describes the benefits and limitations of using galvanic isolation in CAN interface boards, highlighting improved noise immunity, reduced ground loop issues, and a slight reduction...
-
Can I use the simplyCAN with the VCI or ECI?
This article explains that simplyCAN is not compatible with VCI or ECI and can only be used with its dedicated simplyCAN-API. APPLICABLE PRODUCTS simplyCAN QUESTION Can I use the simplyCAN w...
-
Quick start guide for CANnector
Guide to setting up and configuring the Ixxat CANnector using IxAdmin and ACT tools for CAN network communication. APPLICABLE PRODUCTS CANnector, ACT Tool, IxAdmin. QUESTION How to set up and co...
-
Quick start guide for CAN@net NT
Quick setup quide for Ixxat CAN@net NT: Learn how to install, configure and operate the device using the CAN-Gateway Tool and the VCI. APPLICABLE PRODUCTS CAN@net NT 100, CAN@net NT 200, CAN@ne...