Julia_A_Foster_x_468

  • Total activity 9
  • Last activity
  • Member since
  • Following 0 users
  • Followed by 0 users
  • Votes 0
  • Subscriptions 1

Activity overview

Latest activity by Julia_A_Foster_x_468
  • Julia_A_Foster_x_468 commented,

    Hi Chris, We completed the research requested by the client and advised them based on our findings. Thanks, Julia

  • Julia_A_Foster_x_468 commented,

    I can see either PLC on RSLinx as long as my computer is on that subnet. We are trying to use a MSG instruction in RSLogix 5000; message type CIP Data Table Read routed through the Ethernet card (E...

  • Julia_A_Foster_x_468 commented,

    Yes, the IP addresses you mentioned are correct. I have set the NATITF parameter to 3 and updated the firmware to version 12.1s2 and attached a new backup file. Thanks, Julia eWON_MatrixTech_v12-1s...

  • Julia_A_Foster_x_468 commented,

    Hi Joe, Attached is the backup file for our eWON. Thanks, Julia We have a 1756-L61 (LAN) and a 1756-L63 (WAN). We just have a string and an integer in the L61 that we are trying to read the values ...

  • Julia_A_Foster_x_468 commented,

    We have a 1756-L61 (LAN) and a 1756-L63 (WAN). We just have a string and an integer in the L61 that we are trying to read the values of with a MSG instruction (CIP data table read) in the L63. I wi...

  • Julia_A_Foster_x_468 commented,

    Joe, When the 2 Rockwell PLCs are on the same network, the messaging works fine. We would like to avoid opening the WAN to all LAN traffic. I was told that may cause IP conflicts as well as less se...

  • Julia_A_Foster_x_468 commented,

    Joe, I followed the steps outlined in the document including changing the advanced parameters you mentioned below. The mapped WAN IP address is reserved for our device, yes. Thanks, Julia

  • Julia_A_Foster_x_468 created a post,

    Help needed for eWON Cosy 131 NAT 1:1

    Hello, I am working with an eWON Cosy 131 device and having some difficulty getting it to perform as required. We need to configure the device to read info from a Rockwell PLC on the LAN side to a ...