support
- Total activity 32
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 8
Comments
Recent activity by support-
Hello, This did turn out to be a known issue, Trevor found the following. "The IP address for my Linking Device was 192.168.150.171. I tried changing it to something completely different (10.10.0....
-
Hello, If the Fanuc Robot controller is also a PROFINET IO slave device then you will need a PLC like you mentioned. The configuration of this gateway is straightforward because it is a slave on b...
-
Hello, Modbus is supported in the event the application calls for it. You certainly do not need to use it, so you can just ignore that functionality. Thanks! Nick
-
If you are not using Modbus the Modbus addressing mode does not matter. Although it is listed there you can just ignore it. Best regards, Nick
-
Nope, you should be all set, you also have a good day! Nick
-
Hello, Yes, sorry for the inconvenience. CANopen is an protocol that sits on top of a CAN bus. So CANopen defines the object module and what certain messages and CAN IDs mean in the communication ...
-
Hello, If you would like more information please feel free to ask here or your local HMS support office. Thanks! Nick
-
Hello, I apologize for the delay. Could you give a little more detail on what kind of CAN protocol is utilized in this ECU? Is it J1939? Does it use 11-bit or 29-bit CAN ids? The CANopen CM modul...
-
Hello, Unfortunately not, the CM CANopen module does not support CAN 2.0B. J1939 is actually a protocol that uses CAN bus. CANopen is a totally separate protocol that is unrelated to J1939. Best ...
-
Hello, I will have to ask a colleague about this, I will let you know what they say. Thanks! Nick