support
- Total activity 32
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 8
Activity overview
Latest activity by support-
support commented,
Hello, Yes, sorry for the inconvenience. CANopen is an protocol that sits on top of a CAN bus. So CANopen defines the object module and what certain messages and CAN IDs mean in the communication ...
-
support commented,
Hello, If the Fanuc Robot controller is also a PROFINET IO slave device then you will need a PLC like you mentioned. The configuration of this gateway is straightforward because it is a slave on b...
-
support commented,
Hello, Yes, this will have been addressed in the new versions being released. Nick
-
support commented,
Nope, you should be all set, you also have a good day! Nick
-
support commented,
If you are not using Modbus the Modbus addressing mode does not matter. Although it is listed there you can just ignore it. Best regards, Nick
-
support commented,
Hello, Modbus is supported in the event the application calls for it. You certainly do not need to use it, so you can just ignore that functionality. Thanks! Nick
-
support commented,
Hello, This did turn out to be a known issue, Trevor found the following. "The IP address for my Linking Device was 192.168.150.171. I tried changing it to something completely different (10.10.0....
-
support commented,
I have informed a support colleague in Sweden of this behavior. I am going to update him and ask him his thoughts.
-
support commented,
Have you ever been able to launch the configuration interface? Or has it given this message from the very beginning? You are plugged into the X1 ports on the front, correct?
-
support commented,
We have not encountered this exact issue, however I would suggest uninstalling and reinstalling the AOP. This is how you can reinstall it, Navigate to this directory "C:\Program Files (x86)\Rock...