AB7312-B

Completed

vasquez guillaume

• November 06, 2023 08:39
• Edited

Hello everyone,
I have a big configuration problem with the Anybus Config Manager software.
I have an AB7312-B gateway. This gateway will have to control two electric 
actuators via CANBUS. The gateway is connected to the Profibus network, 
to the S7-300 plc.

0

• Official comment

  

  HMS_Support

  • November 06, 2023 10:15

  Hello Mr. Guillaume Vasquez,

  Thank you for your questions.

  We have received your request for these questions on our ticket platform and are currently analyzing it. We appreciate the additional information on electric actuators, which we will add to your basic ticket.

  As a further step, we will close this chat here and keep your basic ticket for further investigation.

  We'll get back to you asap via your ticket, please.

  Thanks for having you here, and see you next time.

  BR

  Francklin F.N.
• 

  vasquez guillaume

  • November 06, 2023 08:37
  • Edited

  I made the profibus config. 
  SFC 14 and 15 which read and write respectively. 
  16 bytes for reading and 16 for writing. 
  Loading config ok exclave dp connected. 
  But the canbus side gateway is either bus off or error passive. 
  Two resistance on the bus. The resistance measurement gives 54ohm. 
  The cylinders are Thomson Electrak HD. The command is cno (canbus).

  0
• 

  vasquez guillaume

  • November 06, 2023 08:33
  • Edited

  Attached are the instructions for the electric actuators. Page 22
  https://www.thomsonlinear.com/downloads/actuators/Electrak_HD_Installation_Operation_mnen.pdf 

  0
• 

  vasquez guillaume

  • November 06, 2023 08:42

  I tried everything, modifying frame, 
  with data, without data, with constant bytes,
   without constant bytes with and without constant word.
   I don't see what's blocking it. I need help please.

  0

Post is closed for comments.