Permanent and triggered (wake-up SMS) cellular connection.

 

This article is intended to explain the different settings available for a cellular connection on your Ewon device.

 

APPLICABLE PRODUCTS

COSY, Flexy

 

PRE-REQUISITES

An Ewon COSY that supports cellular connection (3G,4G) OR a Flexy with a modem extension card.

 

IN THIS ARTICLE

• INTRODUCTION
• TRIGGERED CONNECTION (Wake-up SMS)
• PERMANENT CONNECTION (Maintain connection)

 

INTRODUCTION

 

This option is intended to save data consumed by your Ewon device.

By default, the Ewon is not connected to the Internet trough the 3G or 4G network of your provider.

To be able to connect to your Ewon (and your machine), you have to send an SMS to it.

This can be done two ways :

More info on the Wake-up feature : How to wake-up a cellular-based Ewon?

 

PERMANENT CONNECTION (Maintain connection)

This option will keep the Ewon connected to the Internet through the provider's network, so it'll always stay ONLINE.

This permanent connection can be adapted to your needs by several parameters.

These can all be found and modified in Setup>System>Storage>Tabular edition>Edit COM cfg.

In the case of the Flexy, you can also find them in

Setup>System>Communication>Networking>Internet Connection>Modem>Outgoing>Global

• The Idle Time before hanging up (ClIdle) parameter defines the amount of time after which eWON
  will hang up if no data transfer occurs on the modem link (any type of PPP traffic) during this
  time.
  If you use a VPN connection, due to the keepalive exchange between the VPN client and
  the VPN server, this parameter can be let to default settings.
  If you do not use a VPN connection, then increase the value of this parameter to make sure
  that the line will not be dropped due to communication inactivation.
• The Max outgoing call duration defines the maximum amount of time of the outgoing call.
  When this amount of time is reached, then the eWON stops the modem communication.
  So for permanent connection, increase this amount of time. You can also set this parameter
  to 0, which will deactivate the time limit for the connection. Some GPRS operators do not like that a device stays connected for a too long time period. So in some cases, it may be better to configure the eWON to disconnect and reconnect from time to time on the GPRS network.
• The Call budget management (CallAlloc) allows you to manage the costs of the outgoing connection.
  By default eWON is configured to allow 24 hours of outgoing connection during one week
  (168 hours). Put 0 into the «Allocated budget» field to deactivate the call budget management.