This article will discuss the use case for a PM50A series panel meter used with dual setpoint relay module to maintain and control tank level.
APPLICABLE PRODUCTS
- PM50A series of panel meter
PRE-REQUISITES
- PM50A series panel meter either in 1/16th or 1/8TH Din form factor.
- Level transducer with analog output. 0-10 VDC or 4-20 mA
-
Dual setpoint relay module
IN THIS ARTICLE
Discuss the use case for using a PM50A panel meter for a cost-effective water level indication and control system.
- Part numbers and terminal connection information can be found using the PM50A product manual links below.
Overview
Using the PM50A panel meter with either the dual or quad setpoint relay module. for pump level control. Offers up to 6 setpoint outputs available.
- Note the PM50A panel meter has two solid state outputs standard these are mapped to setpoint 1 and setpoint 2 programming. If you add a dual or quad relay module. You would program setpoint 3 and relay 1 and setpoint 4 as relay 2 and so on.
- setpoints can be setup with hysteresis or dwell times to prevent pump short cycling or multi pump applications using lead and lag pumps.
ADDITIONAL INFO
PM50A Manual pm-50-analog-product-manual-pdf.pdf
PM50A Installation instructions pm-50a-installation-guide.pdf
PM50A Data Sheet pm-50a-data-sheet.pdf
Need additional assistance? Contact us here.
Create a support ticket here
© HMS Networks AB 2026