First, please reference the manual for the sensor in question. Each sensor has unique requirements for gear pitch and speed; and will be referenced throughout the troubleshooting process. This guide assumes that the device is properly configured to accept a sinking input.
APPLICABLE PRODUCTS
- HESS0000
- PSAH series
- LPMC0000
PRE-REQUISITES
One of the above or similar Red lion hall effect sensors
IN THIS ARTICLE
This article provides a troubleshooting guide to help determine input signal issues. Is it a failed sensor or a failed meter input circuit.
Step one
Verify that the unit is being powered
-
Red Lion Hall Effect sensors require 8-30 VDC power in most cases. Determine that the sensor power, common, and signal wires are wired correctly to the panel meter. Correct wiring if necessary.
Verify that the sensing target used is of the correct type for the sensor.
- Some Red lion sensors work only with ferrous containing targets Some will work with non-ferrous targets.
Replace the gear with one made of magnetic material, or replace the sensor with one that can detect non-ferrous materials as required.
Verify that the sensing gear has a proper pitch for the sensor.
-
The larger the gear pitch value, the smaller the gear teeth will be. The minimum gear pitch is the smallest size tooth that the sensor can detect. There must also be a gap between the targets (gear teeth) greater than or equal to the size of the target. Red Lion's Hess Sensors can detect gears as small as 24 D.P. or other ferrous targets with equal or greater dimensions. This information will be listed on the sensor datasheet.
Replace the gear with one that has the correct pitch, or replace the sensor with one that can sense the existing gear as required.
Verify the air gap between the sensor and the gear.
- All Red Lion Hall Effect sensors have a maximum air gap specification. Please consult the datasheet for your sensor model.
* note that a standard credit card is 0.03" thick
Correct the air gap as required
Verify that the gear is moving at the correct speed.
-
All Red Lion Hall Effect sensors have a minimum and maximum speed rating. Consult the datasheet for your sensor model.
- Make sure the sensor you have is rated for the speed range required for the application.
Replace the gear, sensor, or monitoring device to achieve a working system.
ADDITIONAL INFO
Product manual links
Need additional assistance? Contact us here
Create a support ticket here
© HMS Networks AB 2026