APPLICABLE PRODUCTS
NT24k, NT7000
PRE-REQUISTIES
N-Ring Multi-Member configured device behaves similarly to an N-Ring Auto Member except that it is always in an active member state. Each ring the Multi-Member supports will require a membership that binds an existing port set with a specific VLAN. The following screens from the NT24k show how a membership is defined and accessed.
By default, there are no existing memberships by default.
-
At least one membership must exist in order to set Multi-Member mode.
Each membership binds an existing port set with a VLAN and must have a unique one-to-one correspondence.
Like the N-Ring Manager configuration, some VLANs are predefined based on the N-Ring number. Custom N-Ring number can be used to specify non-predefined VLANs.
Like the NT24k, only use of tagged N-Ring frames is allowed.
When the current N-Ring mode is not Multi-Member, existing memberships can be modified.
When the current N-Ring mode is Multi-Member, existing memberships can only be deleted. The last membership cannot be deleted in Multi-Member mode.
Cannot add more memberships than the maximum number of port sets or whatever the maximum is determined to be.
When we create Multi-Member ring membership records on the NT24k, the VLAN is added to the switch and is also added to the ports in that port set (see screenshot below).
Disclaimer
It is the customer's responsibility to review the advice provided herein and its applicability to the system. HMS makes no representation about specific knowledge of the customer's system or the specific performance of the system. HMS is not responsible for any damage to equipment or connected systems. The use of this document is at your own risk. HMS standard product warranty applies.
HMS Technical Support
If you have any questions or trouble, contact HMS Technical Support by clicking here.
For more information: Product warranty and return policy | HMS Networks