Using the Configuration Recovery Device for 700/7000 Switches

Abstract

This tech note will explain how to use the NTCD-128 of the 700/7000 series switch models.

 

N-Tron^® series 700/7000 (709FX, 710FX2, 711FX3, 712FX4, 714FX6, 7010TX, 7012FX2, 7506GX2, 7506GX2-SX, and 7506GX2-LX-10)

 

Switch SD Slot

Certain N-Tron 700/7000 Series managed switches have a SD card slot intended to accept the NTCD-128 configuration device. Please reference the below table to view the location of NTCD slot. The slot itself will be labeled with "NTCD". If you need assistance, please contact HMS Technical Support or click here.
 

NTCD-128

The NTCD-128 is a specially formatted SD memory card that is used for saving or restoring switch configuration parameters quickly without the need for a computer or software. One configuration device per switch is recommended. The NTCD-128 will copy the current configuration from a 700/7000 switch and can be used to "paste" the configuration to another 700/7000 switch of the same model.

NTCD-128 SD Card | HMS
 

The Process to Write to the NTCD-128

Insert the NTCD-128 card in the correct orientation as shown on the label next to the slot. Access the web interface and navigate to the Config page. Additional text will now show up that read "Changes will also be saved to the configuration device.". Hitting "Save" will now save and write a copy of your switch's configuration to the NTCD-128.

The Process to Write to the 700/7000 Switch

The 700/7000 switch must start in a powered off state. Insert the NTCD-128 card in the correct orientation as shown on the label next to the slot. Power on the switch; you can now log into the switch using the IP address and login credentials that was saved to the NTCD-128. Remove the NTCD-128 card and navigate back to Config page and save the configuration the 700/7000 switch.

*Note: The configuration saved the NTCD-128 card MUST originate from the same 700/7000 switch model. You will see a red warning banner if this is not the case. The NTCD-128 format is proprietary. Do NOT attempt to format the NTCD-128 device in your computer/Laptop if prompted - doing so may render your card inoperable with the 700/7000 series.

Disclaimer

It is the customer's responsibility to review the advice provided herein and its applicability to the system. HMS makes no representation about specific knowledge of the customer's system or the specific performance of the system. HMS is not responsible for any damage to equipment or connected systems. The use of this document is at your own risk. HMS standard product warranty applies.

HMS Technical Support

For Technical Support inquiries or to visit our Virtual Help Desk, please click here.

For more information: Product warranty and return policy | HMS Networks