HMS NT4008 Industrial Ethernet Switch IP Routing Tech Note
Abstract
The NT4008 has a powerful feature that will allow inter-VLAN routing between interfaces. This tech note will explain the web user interface (UI) IP Mode feature used to configure the IP stack as a router. After reading this document, you will understand how to:
- Enable routing traffic between all interfaces.
- Create IP Interfaces.
NT4800 Managed Ethernet Switch (All Models)
Note: The maximum number of interfaces supported is 8 and the maximum number of routes is 32. This example is based on the network topology.
The NT4008 IP Mode settings are under Configuration> System> IP to enable inter-VLAN routing. This setting should be changed from Host to Router.
Create the IP VLAN interfaces under IP Interfaces
Configure switch VLAN settings under Configuration> System> VLANs. Here VLANs 10, 20, are allowed and Port VLAN configuration has VLAN10 on port 2 and VLAN20 on port 4 set.
ICMP results pinging from the laptop on VLAN10 to a device on VLAN20.
Disclaimer
The information contained in HMS multimedia content (“HMS Content”) has been made available for informational and educational purposes only. Red Lion does not make any representation or warranties with respect to the applicability, fitness, or completeness of the HMS Content. The HMS Content is not intended to be a substitute for application specific advice. Always seek the advice of your system integrator, IT or other professional with specific knowledge of your systems and application before installing HMS products.
HMS disclaims any and all liability to any party for any direct, indirect, implied, punitive, special, incidental or other consequential damages arising directly or indirectly from any use of the HMS Content, which is provided as is and without warranties.
If you have any questions or trouble, contact HMS Technical Support by clicking here.
For more information: Product warranty and return policy | HMS Networks