Howard burghdurf
- Gesamtaktivitäten 11
- Letzte Aktivität
- Mitglied seit
- Folge ich 0 Benutzer
- Gefolgt von 0 Benutzer
- Stimmen 0
- Abonnements 1
Aktivitätsübersicht
Neueste Aktivität von Howard burghdurf-
Howard burghdurf hat einen Kommentar hinterlassen
So there is this "CIP" section in the HMS users manual: Can this be used to get the Diag Data via a Msg Instruction?Not clear on how this would be set up....Below is My stab at it:
-
Howard burghdurf hat einen Kommentar hinterlassen
Any Thoughts?
-
Howard burghdurf hat einen Kommentar hinterlassen
I did try to "enable Alarms" in the parameters, and also checked the DPV1 box.... But that check box doesn't Un-Gray any of the other items on that Tab: And doesn't result in any additional "mappi...
-
Howard burghdurf hat einen Kommentar hinterlassen
sent under the Ticket
-
Howard burghdurf hat einen Kommentar hinterlassen
sent via a ticket
-
Howard burghdurf hat einen Kommentar hinterlassen
How do you attach files?
-
Howard burghdurf hat einen Kommentar hinterlassen
I do not... I'll be onsite Probably next Wed. and provided I can access the equipment I could get that info.In the Mean time getting back to What I want...In the Mass Flow Controller (I sent the...
-
Howard burghdurf hat einen Kommentar hinterlassen
I am remote so I can't access the equipment... It is pretty old (2018?)
-
Howard burghdurf hat einen Kommentar hinterlassen
So is the Firmware the Hardware Firmware version.... and is the "Configuration Manager" part of the "Firmware"?
-
Howard burghdurf hat einen Post erstellt
EN2PB-R Profibus Node Diagnostics
My understanding about the Profibus Protocol is there is Diagnostic Information that should be part of each Nodes transmission? It doesn't appear the the Gateway (or Configuration Manager SW?) map...