ngilbert

1. Community
2. Ewon - Cosy
3. eWON GE Fanuc - Proficy

ok when at the facility with the ewon, I can connect to the plc using ecatcher over wifi and a wired connection, but I can't connect from our other location so I am thinking it's an issue on our end.

• Kommentar anzeigen
• ngilbert
• 9. Oktober 2017 14:48
• 0 Stimmen

1. Community
2. Ewon - Cosy
3. eWON GE Fanuc - Proficy

I've set the gateway, disabled plug n' route, can now ping the plc, but software still will not connect

• Kommentar anzeigen
• ngilbert
• 4. Oktober 2017 13:43
• 0 Stimmen

1. Community
2. Ewon - Cosy
3. eWON GE Fanuc - Proficy

Does the subnet mask of the fanuc need to match the LAN Subnet Mask of the eWon?

• Kommentar anzeigen
• ngilbert
• 4. Oktober 2017 12:28
• 0 Stimmen

1. Community
2. Ewon - Cosy
3. eWON GE Fanuc - Proficy

Changed the setting on my ewon cozy and set the gateway ip on my PLC to the ewon LAN IP, I can no longer ping the PLC when connected and still cannot go online with the software

• Kommentar anzeigen
• ngilbert
• 29. September 2017 12:59
• 0 Stimmen

1. Community
2. Ewon - Cosy
3. eWON GE Fanuc - Proficy

Ok I am just getting in for the day. I will try this and get back with you. Thanks

• Kommentar anzeigen
• ngilbert
• 29. September 2017 12:25
• 0 Stimmen

1. Community
2. Ewon - Cosy
3. eWON GE Fanuc - Proficy

The hardware will not connect, I was just curiours if anyone had this issue with the Fanuc or Proficy before. I have another eWon at the same facility connected to Allen Bradley PLC and I have had ...

• Kommentar anzeigen
• ngilbert
• 28. September 2017 18:45
• 0 Stimmen