Julia_A_Foster_x_468
- Gesamtaktivitäten 9
- Letzte Aktivität
- Mitglied seit
- Folge ich 0 Benutzer
- Gefolgt von 0 Benutzer
- Stimmen 0
- Abonnements 1
Aktivitätsübersicht
Neueste Aktivität von Julia_A_Foster_x_468-
Julia_A_Foster_x_468 hat einen Kommentar hinterlassen
Hi Chris, We completed the research requested by the client and advised them based on our findings. Thanks, Julia
-
Julia_A_Foster_x_468 hat einen Kommentar hinterlassen
I can see either PLC on RSLinx as long as my computer is on that subnet. We are trying to use a MSG instruction in RSLogix 5000; message type CIP Data Table Read routed through the Ethernet card (E...
-
Julia_A_Foster_x_468 hat einen Kommentar hinterlassen
Yes, the IP addresses you mentioned are correct. I have set the NATITF parameter to 3 and updated the firmware to version 12.1s2 and attached a new backup file. Thanks, Julia eWON_MatrixTech_v12-1s...
-
Julia_A_Foster_x_468 hat einen Kommentar hinterlassen
Hi Joe, Attached is the backup file for our eWON. Thanks, Julia We have a 1756-L61 (LAN) and a 1756-L63 (WAN). We just have a string and an integer in the L61 that we are trying to read the values ...
-
Julia_A_Foster_x_468 hat einen Kommentar hinterlassen
We have a 1756-L61 (LAN) and a 1756-L63 (WAN). We just have a string and an integer in the L61 that we are trying to read the values of with a MSG instruction (CIP data table read) in the L63. I wi...
-
Julia_A_Foster_x_468 hat einen Kommentar hinterlassen
Joe, When the 2 Rockwell PLCs are on the same network, the messaging works fine. We would like to avoid opening the WAN to all LAN traffic. I was told that may cause IP conflicts as well as less se...
-
Julia_A_Foster_x_468 hat einen Kommentar hinterlassen
Joe, I followed the steps outlined in the document including changing the advanced parameters you mentioned below. The mapped WAN IP address is reserved for our device, yes. Thanks, Julia
-
Julia_A_Foster_x_468 hat einen Post erstellt
Help needed for eWON Cosy 131 NAT 1:1
Hello, I am working with an eWON Cosy 131 device and having some difficulty getting it to perform as required. We need to configure the device to read info from a Rockwell PLC on the LAN side to a ...